Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Arlington?
Garage door work in Arlington typically runs $150 – $600 for most repairs, and a brand-new door with installation usually lands between $700 and $2,200. The single most common job, a broken torsion spring, costs $180 – $340 for one spring, and since springs are replaced in matched pairs, a pair runs about twice that. The number you actually pay comes from the written estimate, which is free.
We’re a garage door specialist, so this is the only thing we do. Our technicians have up to 10 years of experience, and we work on the brand you already own, from LiftMaster and Chamberlain openers to Clopay, Amarr, Wayne Dalton, Craftsman, Genie, and Raynor doors. When you call, you’re reaching people who diagnose and fix a door in one visit rather than a generalist squeezing it between other jobs. To get started, reach us at (855) 658-4223.
Garage Door Cost Breakdown (2026)
These are typical estimated ranges for the Arlington market. They cover the work itself, standard hardware, and the labor to do it right. Your written estimate sets the final price, because no two doors are quite the same.
| Service | Typical Estimated Range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
A matched pair of springs usually costs about twice the single-spring range, since the two wear at the same rate and replacing only one tends to leave you back on the phone a few months later. The range on general repair is wide on purpose: a snapped roller and a bent track section live at very different ends of it. New door installation depends heavily on door size, material, and whether the opening needs any framing or trim work before the new door goes up.
What pushes a job toward the top of a range is usually what we find once the door is open and we can see the whole system: a torsion setup that needs both springs and new cables, a panel that’s out of production and has to be matched to a still-available profile, or an opener that’s reached the end of its life and takes the door’s balance with it. What keeps a job at the low end is a single worn part with everything else in good shape. Call (855) 658-4223 for a free estimate and we’ll tell you which end of the range your door falls on.
What Affects Garage Door Pricing in Arlington
- Which part failed. A worn roller or a frayed cable is a quick, low-cost fix. A failed torsion spring or a bent track section is more involved and sits higher in the range.
- One spring or a pair. Springs age together, so a matched pair costs roughly double the single-spring price. We’ll show you the condition of both before we recommend anything.
- Door size and material. A single-car steel door and a double-wide wood or carriage-style door don’t carry the same installation cost. Larger, heavier doors need heavier hardware to carry them.
- Opener brand and age. Because we work across LiftMaster, Chamberlain, Genie, Craftsman, and the rest, most openers you already own are ones we can diagnose and repair rather than replace. A unit that’s genuinely at end of life is a different call.
- Whether it’s a repair or a replacement. If the door’s structure and hardware are sound, repair is almost always the lower-cost path. If panels, tracks, and springs are all worn at once, a new door can make more sense than patching one part at a time.
- Access and condition of the opening. A clean, unobstructed opening with intact framing keeps labor straightforward. Rot, sag, or an out-of-square opening adds steps before the door itself can be worked on.
How to Save on Garage Door Costs in Arlington
The biggest savings come from catching a problem early. A door that’s starting to run rough, squeak, or reverse before it fully closes is telling you something is wearing. Repairing one worn part now usually costs far less than waiting until that part fails and takes a cable or a spring with it.
A few practical ways to keep costs down:
- Get the estimate in writing before work starts. Free estimates mean you know the number up front, and a written estimate is the price you pay.
- Fix the small things first. Roller replacement and track realignment are among the least expensive jobs on the list, and staying on top of them protects the rest of the system.
- Ask about repair versus replacement honestly. If a repair will genuinely restore the door, that’s the lower-cost answer. We’ll tell you when it won’t.
- Keep the door balanced. A door that’s out of balance strains the opener and the springs. Having the balance checked when something feels off is cheaper than replacing the parts it wears out.
- Batch related repairs. If you already know the rollers are worn and the opener is acting up, having both looked at in one visit saves a second trip.
For a no-pressure look at your door and a free estimate, call (855) 658-4223. We’ll walk you through what we find and what it costs before anyone touches a tool.
When Repair Makes More Sense Than Replacement
For most Arlington homeowners, repair is the lower-cost choice, and it usually is when the door’s panels, framing, and tracks are still sound and the failure is in the moving parts. A single broken spring, a snapped cable, a worn roller set, or an opener that’s stopped responding are all jobs that restore a door to full working order without replacing it. That’s why our garage door repair work starts with a full diagnosis: we want to fix the actual problem, not sell you a door you don’t need.
Replacement starts to make sense when several major components are worn at once, when a panel is damaged beyond matching, or when the door itself has structural problems that make repair a patch on a bigger issue. Because we handle both garage door installation in Arlington and repair, you don’t need a second contractor if a door turns out to be beyond saving. We’ll give you both numbers and let you decide.
Opener Problems and What They Cost
Openers are their own category of garage door work, and they’re a big part of what we do. A motor that hums but won’t lift, a remote that’s stopped pairing, a wall button that’s gone dead, or a unit that reverses for no clear reason are all diagnosable, and often repairable, rather than a signal to replace the whole opener. Opener repair runs a typical $120 – $320, and a full opener installation runs $250 – $550.
We service the major opener brands you’re likely to already have: LiftMaster, Chamberlain, Genie, and Craftsman among them. If your opener is one of those, we can usually work with it rather than pushing a new unit. For dedicated help with the motorized side of your door, see our garage door opener repair in Arlington. If the opener is fine but the door itself is the problem, garage door repair in Arlington covers the mechanical side: springs, cables, tracks, rollers, and panels.
Springs and Cables: The Safety-Critical Repairs
Springs and cables are the parts of a garage door that carry the door’s full weight, and they’re under extreme tension at all times. A torsion spring that lets go can cause serious injury, which is why manufacturers and industry groups warn against DIY spring work. This is a job for a trained technician, full stop. We handle spring repair as a core specialty, not an afterthought, and we replace springs in matched pairs because they wear together.
Cable repair is in the same safety category. A frayed or snapped cable can whip loose under load, and a door held up by a compromised cable is a door you shouldn’t be operating. Cable repair typically runs $130 – $250, and spring repair runs $180 – $340 for one spring. If your door is stuck open or won’t lift at all, don’t force it. Call (855) 658-4223 and we’ll talk through what to do safely while you wait for a technician.
Emergency Garage Door Service
A door that won’t close leaves your home open. A door that’s come off its track can be a hazard to anyone walking under it. That’s exactly the situation emergency garage door service exists for, and it’s a named, dedicated offering for us rather than something we squeeze in between other jobs. Emergency service means fast dispatch and a real technician who knows the system, not a surge price for the privilege.
If a door fails, the safest thing to do is keep people and vehicles clear of it and call. We’ll help you figure out whether it’s a job for emergency service or something that can be scheduled. Call (855) 658-4223 and we’ll take it from there.
Neighboring Communities We Serve
Arlington sits close to several communities where homeowners call us with the same kinds of garage door problems. If you’re nearby, we can help. Our garage door repair in Belmont covers doors on the next town over. We also handle garage door repair in Medford and garage door repair in Lexington.
A little farther out, we work on doors with garage door repair in Woburn and garage door repair in Winchester. If you’re not sure whether your address is in range, call and ask. The same pricing ranges and the same free estimates apply.
FAQs – Garage Door Cost in Arlington
How much does a garage door repair cost in Arlington?
Most garage door repairs in Arlington fall between $150 and $600, with the final number depending on which part failed. A single worn roller or a realignment sits near the bottom; a spring or cable job sits higher. Call (855) 658-4223 for a free estimate, and the written quote sets the price.
How much does it cost to replace a garage door spring in Arlington?
Spring repair runs a typical $180 – $340 for one spring, and a matched pair costs about twice that because both springs are usually replaced together. Springs are under extreme tension, so this is a trained-technician job. Call (855) 658-4223 for an exact quote.
Is it cheaper to repair or replace a garage door in Arlington?
Repair is almost always cheaper, and it’s the right call when the door’s panels, framing, and tracks are still sound. Replacement starts to make sense when several major components are worn at once or the door has structural damage. New door installation runs a typical $700 – $2,200. Call (855) 658-4223 and we’ll give you both numbers.
How much does a new garage door opener cost in Arlington?
Opener repair runs a typical $120 – $320, and a full opener installation runs $250 – $550. Many opener problems are repairable, so it’s worth having the unit diagnosed first. Call (855) 658-4223 for a free estimate.
Can you come today if my garage door is stuck?
Often, yes. A door stuck open or off its track is exactly what our emergency service is for, and we dispatch a real technician rather than leaving you to wait. Call (855) 658-4223 and we’ll tell you the soonest we can get to your Arlington home.
Get Your Free Estimate
Garage doors are the only thing we do, so when we look at yours, we know what we’re seeing. Whether it’s a broken spring, an opener that’s quit, a bent track, or a door that’s ready to be replaced, we’ll give you an honest diagnosis and a clear number before any work begins. We service the eight major brands most Arlington homeowners already own, we diagnose and fix in one visit, and our technicians have up to 10 years of experience.
Call (855) 658-4223 today for a free estimate on your garage door in Arlington. We’ll tell you what’s wrong, what it costs, and how soon we can get it done.
Pricing reflects the Arlington market as of 2026. Waltham Garage Door Repair Pros offers free estimates – call (855) 658-4223.
What Our Customers Say
"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Amanda Miller"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Scott Sullivan"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Simone Prince